Volume 30, Issue 2 (Dec 2011)
2011, 30(2): 51-60 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
A. Azimi Dastgerdi, F. Ashrafizadeh, M. R. Toroghinejad, F. Shahriari, H. Zahraei. Evaluation of bare spot defects in hot dip galvanizing and their influence on the properties of steel sheet. Journal of Advanced Materials in Engineering (Esteghlal) 2011; 30 (2) :51-60
URL: http://jame.iut.ac.ir/article-1-528-en.html
URL: http://jame.iut.ac.ir/article-1-528-en.html
Corresponding Author Address: Steel Institute of Isfahan University of Technology , arash.az.ms@gmail.com
Abstract: (9150 Views)
In this paper, bare spot defects in hot-dip galvanized sheets were studied in terms of the microstructure and their influence on the corrosion and mechanical properties. Surface characteristics and microstructural features were examined by scanning electron microscopy equipped with energy dispersive spectroscopy microanalysis system. The results showed that the major cause of the bare spots was the lack of wetability of the sheet surface due to contamination, improper heat treatment or chemical composition. Corrosion resistance was evaluated by standard salt spray test. Mechanical properties were examined by tensile testing. The time to red rust was much shorter on the bare spots as compared to other regions, but it appeared that bare spot defects had no significant effect on the mechanical properties of the galvanized steel sheets.
Type of Study: Research |
Subject:
General
Received: 2015/02/9 | Accepted: 2015/05/5 | Published: 2015/05/5
Received: 2015/02/9 | Accepted: 2015/05/5 | Published: 2015/05/5
Send email to the article author
