Volume 38, Issue 2 (Journal of Advanced Materials-Summer 2019)
2019, 38(2): 1-10 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Samii Zafarghandi M, Abbasi S M. Hot Deformation Behavior of Haynes 25 by the Hot Tensile Test. Journal of Advanced Materials in Engineering (Esteghlal) 2019; 38 (2) :1-10
URL: http://jame.iut.ac.ir/article-1-987-en.html
URL: http://jame.iut.ac.ir/article-1-987-en.html
Metallic Materials Research Center, Malek Ashtar University of Technology, Tehran, Iran. , sma.abbasi95@gmail.com
Abstract: (5424 Views)
In the present work, hot tensile behavior of Haynes 25 Co-base alloy was investigated in the temperature range of 950-1200 ˚C and 0.1 s-1. Thermodynamic calculations showed that M23C6 and M6C carbides were stable below 1000 ˚C and above 1050 ˚C, respectively. Stress-strain curves also indicated an unusual trend of strain fracture. It was observed that with increasing temperature from 950 to 1050 ˚C, the fracture strain was decreased, while it was raised above 1050 ˚C again. Increasing the volume fraction of M6C carbide rich in Tungsten resulted in the loss of ductility. Also, microstructural evaluations showed dynamic recrystallization (DRX) grains were nucleated and growth was around carbides and the initial grains at 1150 ˚C. Occurrence of DRX led to the improvement of ductility via grain refinement mechanism, so this alloy had the highest level of ductility at 1150 ˚C
Type of Study: Applicable |
Subject:
Forming and mechanical properties
Received: 2018/07/31 | Accepted: 2019/04/14 | Published: 2019/09/15
Received: 2018/07/31 | Accepted: 2019/04/14 | Published: 2019/09/15
Send email to the article author
