Showing 3 results for Borouni
R. Jamshidi-Alashti, M. Borouni, B. Niroumand,
Volume 32, Issue 2 (Dec 2013)
Abstract
Application of ceramic reinforcements is one of the effective and well-known ways to refine the microstructure of brittle metals such as magnesium. In this research, the influence of nano/micro particles of zirconia on the microstructure of cast AZ91 alloy was studied. At the first stage, nano and micro ZrO2 powders were blended through mechanical alloying procedure. In five specimens, the total amount of nano and micro reinforcements in the final mixture was fixed at 5 wt%, whereas their ratio was varied. Two other composites were also produced using 5wt% of nano or micro particles of zirconia. These powder mixtures were then stirred in the molten AZ91 at 650C by vortex method and finally cast in a sand mold at 615C. For comparison, two monolithic castings including a conventionally cast specimen and a super heat-treated sample were also cast. The average grain sizes for all composites were decreased with respect to both monolithic castings. The best results in terms of grain size and microstructure improvement were obtained for AZ91/5wt% nano ZrO2 composite with remarkable improvement in comparison with monolithic castings.
B. Hassani, F. Karimzadeh, M. Enayati, M. Borouni,
Volume 35, Issue 1 (Journal of Advanced Materials-Spring 2016)
Abstract
In this study, TIG welding was used to clad and repair the surface of cast AZ91C magnesium alloy. Then, friction stir processing and T6 heat treatment wrer applied on the welded region. Microhardness results showed an improvement in the mean hardness of welded zone and also FSPed zone. Increase in the mean microhardness of the welded zone after T6 heat treatment to the maximum value was also concluded. The results of wear test showed that the wear resistance of the welded area was improved. Further improvement in wear properties was obtained after friction stir processing and T6 heat treatment.
A. Borouni, A. Kermanpur,
Volume 39, Issue 3 (Journal of Advanced Materials-Fall 2020)
Abstract
In this study, the effect of Ta/W ratio on the microstructure and stress rupture properties of Ni-based single crystal (SX) superalloy PWA1483 was investigated. For this purpose, single crystal (SX) superalloys with different Ta/W ratios (0.75, 1.0, 1.32 and 1.5 in wt.%) were fabricated. The alloys were directionally solidified by Bridgman method under the same solidification condition at withdrawal velocity of 3 mm/min and thermal gradient of about 7 K/mm followed by standard age hardening heat treatment. Microstructural characterization was performed using optical microscopy (OM) and scanning electron microscopy (SEM). The stress rupture properties were investigated at 982 °C and 248 MPa. The results showed that increasing the Ta/W ratio decreases the size and volume fraction of micro-pores together with the size of γ' precipitates. Hence, the stress rupture life increased. The superalloy with Ta/W ratio of 1.5 showed the minimum size of micro-porosity (18.2 μm) and the maximum stress rupture life (~34 h). The superalloy with Ta/W ratio of 1 showed the most uniform microstructure and creep behavior. It seems that the presence of topologically closed packed (TCP) η-phases is the main reason for stress rupture life decrease in SX superalloy as micro-pores initiated from TCP phases or the TCP/matrix interfaces.
