Showing 2 results for M. Ahmadi
M. Bahrami, M.h. Fathi, M. Ahmadian,
Volume 32, Issue 1 (Jun 2013)
Abstract
Short life of current total hip replacement metallic implants is generally dependent on the aseptic loosening of the implant, which occurs due to mismatch of elastic modulus between bone and metallic implant materials. Decreasing in elasticmodulus of implant could be successful. Forsterite is biocompatible and bioactive ceramic which has suitable mechanical properties. In presented research the composite materials based on Co-Cr-Mo alloy with 10, 15 and 20wt% of forsteritenanopowder as reinforcement were fabricated and mechanical behavior of the composites were evaluated. Composites were fabricated by ball milling, cold pressing and sintering. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were used for characterization and evaluation phase composition and microstructure of the composites. Density, microhardness, compressive strength and elastic modulus of fabricated composites were evaluated. Obtained results showed elastic modulus of composite materials based on Co-Cr-Mo alloy reinforced with 10, 15 and 20wt% of forsteritenanopowder decreased significantly. Results also showed that the compressive strength of Co-base alloy composites reinforced with 10, 15 and 20 wt% forsterite were lower than cast Co-Cr-Mo alloy. With increasing in the content of reinforcement, compressive strength of the composites were decreased. Microhardness of prepared composites were higher than cast Co-Cr-Mo alloy. With increasing in content of bioceramic reinforcement, microhardness of the composites were increased.
M. Ahmadi, Sh. Ebrahimi, M. Ahmadi,
Volume 33, Issue 2 (Journal of Advanced Materials-fall 2015)
Abstract
This research aimed at producing microcellular foams (with cell size of 1-10 μm and cell density above 10 9 cell/cm3)
from PC/EPDM in order to use in medical devices. Due to the weak nucleation behavior of microcellular polycarbonate foams, it is difficult to prepare them. This research provides valuable information regarding the possibility of making microcellular foams from this polymer by using multiwalled carbon nanotubes (MWNT,s) as nucleating agents (the value of 1-3 phr). The nanocomposite samples were prepared in an internal mixer and foamed via a batch processing method using supercritical carbon dioxide as the foaming agent. The results showed that the addition of nanoparticles up to 3 phr improves the foamability of PC/EPDM blend. Furthermore, as nanoparticle content increased a decrease in cell size and hence an increase in cell density were observed. Another finding showed that cell size distribution is directly related to uniform dispersion of carbon nanotubes.
