Search published articles


Showing 2 results for Bulk Metallic Glass

M. T. Asadi Khanouki, R. Tavakoli , H. Aashuri,
Volume 38, Issue 2 (9-2019)
Abstract

In this research, the effect of temperature on the mean size of fracture surface features, as well as the relation between fracture surface morphologies and ductility of a La-based BMG as a relatively brittle alloy, was systematically investigated. After producing the alloy, three-point bending experiments, over a wide range of temperatures, were conducted on the samples; then the fracture surfaces were analyzed using scanning electron microscopy. The results demonstrated that the width of stable crack growth region (ΔW) was increased upon ductility (δp). Conversely, the mean size of the features on both stable (Ds) and fast (Df) crack growth regions and also, shear offset width (ΔL) were found to decrease with increasing ductility. In this case, the shear band instability was reduced, and the plastic strain could be more homogeneously distributed on the shear bands. The similarity of ΔL and Ds values suggested that the formation of vein pattern was caused by steak-slip behavior and multiple-step sliding inside the shear band through the fluid meniscus instability mechanism. Furthermore, the results obtained from correlation between ductility and fracture surface morphologies in the BMG indicated that the size of features was reduced with increasing ductility.

M. T. Asadi Khanouki,
Volume 39, Issue 3 (12-2020)
Abstract

In this study, the influence of temperature and strain rate on plastic flow of a Zr-based bulk metallic glass (BMG) during the three-point bending test was studied to find a correlation between strain rate sensitivity (m) and flow behavior. The flexural stress-deflection curves revealed two distinct types of dynamics, serrated and non-serrated flow, related to temperature and strain rate. The serrated flow which appeared at temperatures higher than a critical value or strain rates lower than a critical value, was simultaneously due to activation of shear transformation zones (STZs) and time-dependent structural relaxations. Further results indicated negative and positive values of m at temperatures above and below 0.4 Tg, respectively. The main reason for negative strain rate sensitivity was insufficient time of structural relaxation at high strain rates which lead to generation of free volume inside shear bands making the BMG softer. Comparison of STZ activation energy with activation energy for the onset of serration indicated almost equal values and there was a close relationship between serrated flow and STZ operation.


Page 1 from 1     

© 2024 CC BY-NC 4.0 | Journal of Advanced Materials in Engineering (Esteghlal)

Designed & Developed by : Yektaweb