Showing 4 results for Saghafian
M. S. Saidi and M. Saghafian, ,
Volume 20, Issue 1 (7-2001)
Abstract
In this paper, the oscillating two-dimensional laminar flow about a cylinder and the oscillation of a cylinder in still water are studied. A finite volume method is applied to solve the Navier Stokes equations using SIMPLEC algorithm on a body fitted co-located O-type grid. In this study, the non-dimensional flow numbers, Keulegan-Carpenter and Stokes’ numbers are chosen over a range where different laminar flow regimes are normally three-dimensional. The results of this simulation and comparison with numerical and experimental works indicate the good capability of this two-dimensional model in showing the various regimes of flow patterns and vortex shedding. Considering the forces exerted on the cylinder, this study shows that in cases where the flow is of a
regular type, there is a good match between longitudinal force presented by this work and the one calculated through Morrison’s equation. But for irregular flows where the flow pattern changes in each cycle, there is less overlap and the accuracy of Morrison’s equation is reduced. Studying the time variation of the transversal force gives accurate information about the vortex shedding and its frequency in each cycle and mode changing. Since the flow mode changes continuously with time, the average of transversal and longitudinal forces on consecutive cycles is not a good representation of the force exerted on the cylinder. On the other hand, the model has satisfactorily reproduced the time variation of the tranversal and longitudinal forces of a pure mode, matching the experimental results.
Keywords: Oscillating flow, Laminar flow about a cylinder, Numerical solution
B. Saghafian, S. Rahimi Bandarabadi, H. Taheri Shahraeeni and J. Ghayoomian,
Volume 24, Issue 1 (7-2005)
Abstract
Rainfall is one of the most important climatic variables in the hydrology cycle. In flood estimation as well as environmental pollution studies in medium to large watersheds not only mus temporal pattern of rainfall t be known, but also the knowledge of its spatial distribution is required. Estimation of daily rainfall distribution without comparison and selection of
suitable methods may lead to errors in input parameters of rainfall – runoff models. Interpolation methods are among the techniques for estimating spatial distribution of rainfall. In this study, Thin Plate Smoothing Splines (TPSS), Weighted Moving Average (WMA) and Kriging are applied to estimate spatial daily rainfall in the southwest of Iran. Cross validation technique is used for comparison and evaluation of the methods. The results of analysis with two different station density showed that the TPSS method with power of 2 is the most accurate method in estimating daily rainfall. Zoning of the region also increased the interpolation accuracy. Generally speaking, division of the region based on cluster analysis improves accuracy compared with division by inter basin boundaries
R. Rajabi, M. Saghafian,
Volume 35, Issue 1 (9-2016)
Abstract
In this paper, viscous dissipation and roughness effects on heat transfer and fluid flow are investigated in microchannels using perturbation method in slip flow regime. The flow is considered to be laminar, developing thermally and hydrodynamically, two-dimensional, incompressible and steady-state. The working fluid is air, flowing between two parallel plates. The equations obtained from developing Navier-Stokes and energy equations are solved numerically according to different orders of Knudsen number, with second-order velocity slip and temperature jump boundary conditions. The effects of thermal creep has been ignored. Tempreture and velocity fields are obtained and estimated for both constatnt heat flux and constant wall tempreture. The effects of roughness height, space between roughness elements, roughness elements length, Re number and Kn number on slip behavior of gas flow are investigated.The results indicate considerable effect of viscous dissipation and roughness on fluid flow and heat transfer in microchannel.
F. Shabani, M. Saghafian, D. Saeidi, F. F. Momennasab ,
Volume 39, Issue 2 (2-2021)
Abstract
Particulate separation has many applications in medicine, biology and industry. In this research, the separation of polystyrene particles with a diameter of 10, 20 and 30 μm in the fluid flow of a microchannel is investigated. The microchannel consists of a spiral region and a straight region under the influence of acoustic waves. In the spiral region, the particles under hydrodynamic effects undergo the initial separation; then the particles enter the straight region of the microchannel, and the final separation of the particles is done by the force generated and exerted through the acoustic waves. The effects of acoustic frequency and the number of spiral region loops on separation are investigated. The results show that for measured dimensions and parameters, at 1 MHz acoustic wave, when the number of loops is 2 for the spiral region, the particles at the end of the path are in a suitable position for separation. In addition, the results show that the separation of particles with this hybrid system is better than that done by the simple methods, and the separation rate can be as high as 100%
