Showing 4 results for Microstructure
M. Shamanian, A. Saatchi, M. Salehi and T. H North,
Volume 21, Issue 2 (1-2003)
Abstract
The metallurgical and mechanical properties of Ti6Al4V/(WC-Co) friction welds have ben investigated. The microstructure close to the bondline comprised a mixture of acicular and equiaxed α plus β phases. The diffusion of elements in the welded specimens has been detected. The fracture strengths of Ti6Al4V/(WC-Co) friction welds markedly improved when the cobalt content in the (WC-Co) carbide substrate increased.
During the three-point bend testing of Ti6Al4V/WC-6wt.%Co welds, the crack initiated at the bondline region at the periphery of the weld and then propagated into the brittle (WC-6wt.%Co) substrate, while with the Ti6Al4V/WC-11 wt.%Co and Ti6Al4V/WC-24wt.%Co welds, the crack initiated and propagated at the bondline region.
Keywords: Friction welding, Ti6Al4V alloy, Cemented tungsten carbide, Microstructure, Fracture strength
H. Moslemi Naeini, M. Maerefat and M. Soltanpour,
Volume 22, Issue 1 (7-2003)
Abstract
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material behaviors at elevated temperatures are usually rate-sensitive, the analysis of the hot forming processes requires a thermo-viscoplastic model. In this paper, by coupling the flow stress prediction model developed with finite element analysis of thermo-viscoplastic of the hot upsetting process, temperature, strain rate, flow stress distributions and geometry of the workpiece at each time step can be calculated. At each time step, the strain rate and temperature at each element are obtained. From these values and the history of deformation, the changes in microstructure and flow stress can be determined.
Keywords: Hot forming, Process, Finite element analysis, Flow stress, Microstructure, Hot upsetting process
A.r. Kiani Rashid and M. A. Golozar,
Volume 22, Issue 2 (1-2004)
Abstract
M. Shamanian and A. Saidi,
Volume 24, Issue 1 (7-2005)
Abstract
The 25Cr-35Ni heat resistant steel has been widely used when resistance to oxidation and creep rapture at elevated temperatures is required. In this paper, the microstructural effect on the weldability of this alloy is investigated. The results of this study indicate that this steel has a perfect weldability in the as cast condition but does not possess good weldability in the aged condition. The as cast microstructure of 25Cr-35Ni steel consists of austenite matrix and a network of primary carbides, while the aged condition consists of austenite matrix and y primary and secondary carbides. The morphological change of primary
carbides and the secondary carbides precipitate formation, reducing the elongation and ductility of aged steel, should have enhanced the steel susceptibility to cracking, particularly in the area of the eutectic carbides, and hence, the reduced weldability of the steel. The cracking observed was of the intergranular type and spread along the eutectic carbides. It was found that the carbides in the as cast steel consisted of NbC and M23C6, whereas that of the aged steel also exhibited Ni16Nb6Si7 and M23C6 carbides
