Volume 16, Issue 59 (spring 2012)                   jwss 2012, 16(59): 169-182 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

H. Emami, M. SHorafa, M. R. Neyshabouri. Evaluation of Hydraulic Conductivity at Inflection Point of Soil Moisture Characteristic Curve as a Matching Point for some Soil Unsaturated Hydraulic Conductivity Models. jwss 2012; 16 (59) :169-182
URL: http://jstnar.iut.ac.ir/article-1-2206-en.html
, hemami@ferdowsi.um.ac.ir
Abstract:   (20830 Views)
Direct measurement of soil unsaturated hydraulic conductivity (K(h) or K(θ)) is difficult and time-consuming, and often in many applied models, predicting hydraulic conductivity is carried out according to measurements of soil retention curve and saturated hydraulic conductivity (Ks). However, using KS as a matching point in many procedures may result in over-estimation of unsaturated hydraulic conductivity in dry regions. Therefore, the unsaturated hydraulic conductivity at inflection point of retention curve (Ki) and Ks was used as a matching point to predict K(h). For measurement of K(h), 30 soil samples were collected based on variety of soil texture (8 texture classes from sandy to clay) and other chemical and physical properties. In addition to Ks, K(θ) values of undisturbed samples were measured using multi-step outflow method at matric suctions of 0.1, 0.2, 0.3, 0.5 0.7, 1 bar and inflection point of retention curve by using hanging water column and pressure plate. Then, the measured K(h), and water diffusivity (D(θ)) values were compared to the predicted values of van Genuchten and Brooks and Corey models (with Mualem and Burdine constraint). The results showed that for 80% of the samples, the van Genuchten–Mualem model with Ki was the best model for predicting K(h) (i.e. using Ki as a matching point in the van Genuchten–Mualem model resulted in best fitting to measured data). Also, in 6.7 % of samples (two sandy clay samples), Brooks and Corey-Mualem model with Ki and in 13.3 % soil samples (2 silty clay and 2 silty clay loam samples), van Genouchten–Mualem model had a best fitting to K(h) measured data. Furthermore, in 20 % samples (4 clay loam, and 2 silt loam textures), the accuracy and efficiency of van Genuchten–Mualem with Ki and van Genuchten–Mualem models in predicting K(h) were almost similar. According to t-Student test, the mean of RMSE and GSDER of van Genuchten–Mualem model with Ki was significantly less than van Genuchten–Mualem model at P < 0.01. In 90 percent of samples, van Genuchten-Mualem and Brooks and Corey-Burdine theory had the best fitting to the measured data of water diffusivity, but in some cases van Genuchten-Burdine model with Ki was the best model for predicting D(θ).
Full-Text [PDF 406 kb]   (3626 Downloads)    
Type of Study: Research | Subject: Ggeneral
Received: 2012/07/4 | Published: 2012/04/15

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | JWSS - Isfahan University of Technology

Designed & Developed by : Yektaweb