Volume 28, Issue 2 (Summer 2024)
jwss 2024, 28(2): 163-176 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Ebrahimi Golbosi H, Fazel Najafabadi E, Shayannejad M. Determining the Coefficients of Philip's Equation and the Optimal Roughness Coefficient Using the Simulation of the Advancing Phase in Border Irrigation with the Dynamic Wave Model. jwss 2024; 28 (2) :163-176
URL: http://jstnar.iut.ac.ir/article-1-4407-en.html
URL: http://jstnar.iut.ac.ir/article-1-4407-en.html
Department of Water Engineering, College of Agriculture, Isfahan University of Technology, Isfahan, Iran. , shayannejad@iut.ac.ir
Abstract: (493 Views)
Surface irrigation is one of the most common irrigation methods. Due to the low efficiency of surface irrigation, water loss is significant in this system. It is necessary to know the characteristics and coefficients of water infiltration rate in the soil for accurate and adequate planning of surface irrigation. One of the equations used in this field is Phillip's infiltration equation. In this study, the infiltration coefficients of Phillip's equation and Manning's roughness coefficient in border irrigation are determined based on the comparison of the actual advance curve with the advance curve calculated with the dynamic wave model, and the results were compared with the double cylinder method and the two-point method of Ebrahimian et al. (5). The actual infiltration volume was obtained from the difference between the inlet and outlet volumes. The error of the mentioned method in calculating the infiltration volume was 5.53%. Meanwhile, the errors in the double cylinder and two-point Ebrahimian (5) method were 59.62% and 19.08%, respectively. In heavy soils, the longer the length of the border increases, the method is more accurate in estimating Philip's coefficients, while in light soils, the advancing time, which in addition to length is a function of permeability, input discharge, and the slope of the bottom of the bed is increased, the accuracy of the method in estimating Philip's penetration coefficients is increased.
Keywords: Border irrigation, Optimization, Flow resistance coefficient, Irrigation phase, Philip's equation, Infiltration
Type of Study: Research |
Subject:
Ggeneral
Received: 2024/02/14 | Accepted: 2024/05/19 | Published: 2024/08/31
Received: 2024/02/14 | Accepted: 2024/05/19 | Published: 2024/08/31
| Rights and permissions | |
 | This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
