Showing 4 results for Nourmahnad
N Nourmahnad, M Emamzadei, B Ghorbani, A.r Mohamdkhani,
Volume 13, Issue 50 (winter 2010)
Abstract
Water scarcity causes production losses in arid and semi arid regions. In this condition, deficit irrigation is one of the most important methods to minimize effects of water shortage. This research was conducted to evaluate the effects of two kinds of irrigation management (deficit irrigation and partial rootzone drying technique) on some of physiological and phenological characteristics and water use efficiency of tomato. The experiment was carried out in a completely randomized design with five treatments and four replications. The treatments consisted of DI75 and DI50 (supplying 75% and 50% water requirement) applied to the whole root system, PRD75 and PRD50 (supplying 75% and 50% water requirement) which was applied to one side of the root system, and alternated in every irrigation, and FI treatment, which supplied 100% water requirement, and was considered as control. The results showed that the highest water use efficiency was observed in PRD75 (6.28 kg/m3) and the lowest in DI50 (1.98 kg/m3). Water use efficiency was reduced 67% in DI50 and increased 4.6% in PRD75, as compared with full irrigation. Furthermore, plant water state showed that relative water content was higher in PRD treatments than DI treatments. The analysis of variance indicated that there was a significant difference in leaf diameter stomata among treatments at 5% level .The higher level of water increased stomata diameter. The opening of stomata in FI and DI treatments was higher than PRD treatments. FI had the highest numbers of stomata per unit of leaf area and PRD50 had the lowest (10509.04 and 6904.4, respectively). There was no difference among treatments in phenological characteristics in terms of growing degree-day to fruit yield and growing-degree day to harvesting.
N. Nourmahnad, H. Tabatabaei, A. R. Hoshmand, M. R. Nouri Emamzadei, Sh. Ghorbani Dashtaki,
Volume 18, Issue 68 (summer 2014)
Abstract
Usually, dry soil readily absorbs water .However, not all soils display such characteristics. Some soils (hydrophobic soils) show resistance to wetting. Because of the importance of this subject and lack of research, we evaluated the effect of heating on water repellency and some of soil physical and chemical characteristics. So soil was combined with compost and heated at deferent temperatures, 100, 200, 300, 400 and 500 °C for 30 minutes in an oven or muffle furnace. The results showed that control treatment and heated soil at 300 °C had WDPT and MED 45 (s), 17% and 80 (s), 23% respectively. So, little water repellency was present prior to heating the soil. When soil was heated up to 300°C, intense water repellency resulted, but it was abruptly eliminated by increasing the heating. The soil texture was changed from loam to sandy loam at high temperatures (400 & 500 °C) and the sand percentage was increased. Organic matter decreased by increasing the temperature. Amount of pH decreased up to 200 °C and then increased at 500°C because of increasing ash in soils. Diminution of mineral and organic matter caused EC to decline in all the heated soils.
N. Nourmahnad,
Volume 22, Issue 2 (Summer 2018)
Abstract
Due to the water scarcity in Iran, it is important to provide strategies to reduce water consumption in the agriculture sector. Zycosil is a nanotechnology material that makes a great hydrophobe in the soil. This study was conducted based on completely randomized block design within microlysimeter with the height of 15 cm and the diameter of 8 cm to investigate the hydrophobic effect on the amount of consumed water in pepper. Sweet pepper seedlings were planted in them; then the treatments were applied. The Z25, Z50 and Z75 treatments consisted of covering 25, 50 and 75 % of the soil surface by Zycosil; these were compared with the control (Ctrl- no Zycosil application) in three replications. The results showed that Z75 treatment reduced 27% water consumption and increased the fresh yield by approximately 62 %. The increased yield of Z25 and Z50 was 5 and 26 %, respectively. Dry pepper yield was increased in Z25, Z50 and Z75 treatments by 22, 19 and 80%, respectively, as compared to Ctrl treatment. The amount of water consumed was decreased by 10 % per 25% coverage level. The least amount of water use efficiency was observed in the control treatment (1.28 gr/cm3). The Z75 had the highest water use efficiency (2.96 gr/cm3). Hence, the application of hydrophobic material such as Zycosil in the soil surface reduced water evaporation and increased water retention. This increased the yield and water use efficiency.
R Mousavi Zadeh Mojarad, S. H. Tabatabaei, N. Nourmahnad,
Volume 25, Issue 2 (Summer 2021)
Abstract
The contact angle is a numerical index of differentiation between hydrophilic and hydrophobic soils. The objectives of this research are: 1) assessing different methods such as capillary rise, the molarity of ethanol droplet, repellency index, and sessile drop, and 2) Determining the most efficient method in a typical soil with sandy loam texture. In this study, hydrophobic soil was hydrophobized artificially using stearic acid and according to the water drop penetration time classification method. Calculated contact angles of hydrophilic soil with capillary rise method, the molarity of ethanol droplet method, repellency index (two methods of calculation), and sessile drop method were 89.9, 75.41, (57.81), 56.28, and 58.91, respectively. Using the contact angle measuring device, the contact angle of five hydrophobic levels were 58.91, 104.92, 120.48, 129.96, and 173.07, respectively. According to the precession of the device where the operator is capable to control data and processes and there is no limitation in usage, therefore, the sessile drop method is the most suitable method to measure contact angle. The contact angle of the late method and water drop penetration data are positively correlated (R2 = 0.975).
