Search published articles


Showing 2 results for Tayebi

M. Tayebi, M. Naderi, J. Mohammadi,
Volume 21, Issue 3 (Fall 2017)
Abstract

The aim of this work was to study distribution of some heavy metals in different soil particle-size fractions and to assess their spatial distribution. The study was carried out in Kafe Moor (Kerman, Iran) where the Gol-Gohar Iron Mine is located. One hundred twenty composite soil samples were randomly collected and transferred to the laboratory in bags. After air-drying, the samples were fractionated into six classes including 2- 0.5, 0.5-0.25, 0.25-0.125, 0.125- 0.075, 0.075-0.05 and <0.05 mm. Elemental concentrations (Fe, Mn, Cu, Zn, Pb and Ni) were determined using acid digestion method (HNO3, 4.0 N) and an atomic absorption spectrophotometer in each class. Ordinary Kriging technique was used for predicting spatial distribution of heavy metals. The results showed that content of metals in soil increased with decreasing particle size. The results also showed that the concentration of Fe, Mn, Cu, Zn, Pb and Ni in <0.05 mm size fraction were 2.13, 1.70, 4.79,2.43, 1.42, and 3.47 times higher than in 2-0.05 mm size fraction, respectively. In addition, mapping the concentrations of heavy metals with kiriging showed that metals pollution decreased with increasing distance from mines area.
 


Noroullah Mirghaffari, Mohsen Soleimani, Azita Tayebi,
Volume 30, Issue 1 (spring 2026)
Abstract

As the industry expands and water resources decline, attention has increasingly focused on the treatment and recycling of wastewater generated by various industrial processes. Adsorption using cost-effective and readily available adsorbents is a simple and low-cost method for wastewater treatment in various industrial sectors. In this study, clinoptilolite natural zeolite (CNZ) was employed for the removal of two dye pollutants: cationic methylene blue and disperse red 60. To evaluate the efficiency of CNZ, four variables, pH, contact time, adsorbent dosage, and initial dye concentration, were investigated using response surface methodology. Based on the results obtained from batch experiments, the maximum removal efficiencies of methylene blue and disperse red 60 by CNZ were 98.9% and 78.7%, respectively. These optimal removal percentages were achieved under the following conditions: a contact time of 120 minutes, an initial dye concentration of 50 mg/L, an adsorbent dosage of 20 g/L, and a pH of 10 for methylene blue and a pH of 4 for disperse red 60. The pseudo-second-order kinetic model, with an R² value greater than 0.90, exhibited the best fit for the adsorption of both dyes from aqueous solutions. Furthermore, the extent of dye adsorption exhibited a better correlation with the Langmuir (Disperse Red 60) and the Freundlich (Methylene Blue) adsorption isotherms. Results of column experiments demonstrated that the maximum adsorption capacities for Methylene Blue and Disperse Red 60 were 97.7 and 45.9 mg/g, respectively. The results revealed the high potential of CNZ as a sorbent for cationic dye pollutants from industrial wastewaters.

Page 1 from 1     

© 2026 CC BY-NC 4.0 | Journal of Water and Soil Science

Designed & Developed by: Yektaweb

تحت نظارت وف بومی