Search published articles


Showing 23 results for Drainage

E. Karamian, M. Navabian, M.h. Biglouei, M. Rabiei,
Volume 28, Issue 1 (5-2024)
Abstract

Cultivation of rapeseed as the second crop requires drainage systems in most of the paddy fields of the Guilan province. Mole drainage, as a low-cost and shallow drainage method that is suitable for rice cultivation conditions and easier to implement than pipe drainage, can be a solution in the development of second-crop cultivation. The present study was conducted to evaluate the drainage of mole drainage and nitrogen fertilizer management on the quantity and quality of drainage at Guilan University. In this regard, an experiment was conducted under two treatments including drainage and nitrogen fertilizer (i.e. traditional mole drainage and sand-filled mole drainage), and 180 and 240 kg of nitrogen fertilizer per hectare in three replications. After each rainfall during the plant growth period, water samples were taken from the drains, and parameters of electrical conductivity, pH, total suspended solids, total phosphorus, turbidity, concentrations of ammonium, chloride, nitrite, nitrate, and phosphate were measured. Also, the outflow from the drains and the water table level were measured by piezometers during the rain and after that. The results of the mean comparison of pH and total suspended solids showed that most of them were obtained with 7.49 and 281.25 mg/liter, respectively, in the mole drain filled with sand and the traditional mole drainage and 180 fertilizer treatment. The highest mean of electrical conductivity and turbidity was observed as 651 micro mohs/cm in the traditional mole drainage and 240 fertilizer treatment and with 67.76 NTU in the traditional mole drainage and 180 fertilizer treatment. The statistical analysis showed that the effect of drainage treatment on the amounts of ammonium, nitrite, nitrate, phosphate, and total phosphorus was not significant. The outflow from the traditional mole drainage was 49% lower than the sand-filled mole drainage. The traditional and sand-filled mole drains were able to drain excess water with average reaction coefficients of 0.8 and 0.83 per day during the growth period, respectively. Considering the speed of water discharge, drain discharge, and the main non-significance of qualitative parameters among drainage treatments, mole drainage filled with sand is recommended for the development of rapeseed cultivation in paddy fields.

Kosar Neysi, Mehdi Daryaee, Seyed Mahmood Kashefipour, Mohammadreza Zayeri,
Volume 29, Issue 4 (12-2025)
Abstract

One of the key challenges in the design of side weirs is enhancing discharge efficiency, which is defined as the dimensionless ratio of the flow rate over the weir to the total incoming discharge. This study investigates the hydraulic performance of a converging side weir equipped with flow-guiding side plates. A three-dimensional numerical model using FLOW-3D software was employed to simulate flow conditions in the presence of guide plates with varying angles, relative lengths (defined as the ratio of plate length to the upstream channel width), and installation positions, to identify hydraulically optimal configurations. Following validation of the model against experimental data, 28 different scenarios were evaluated. The results demonstrated that under proper conditions, the installation of side guide plates can significantly improve discharge efficiency. Among all cases, the configuration with a 60° deflecting angle and a relative length of 0.2, installed at the upstream location (X₁) of the weir, yielded the best performance, increasing efficiency from a baseline of 62% to 82%. Analysis of the velocity field further revealed that the formation of a low-velocity zone behind the plate plays a critical role in directing the flow toward the weir. Overall, the use of side guide plates presents a simple, low-cost, and effective solution for enhancing the hydraulic performance of converging side weirs without requiring structural redesign.

Jalil Kermannezhad, Hassan Torabipoodeh, Elham Ghanbari-Adivi, Babak Shahinejad,
Volume 30, Issue 3 (10-2026)
Abstract

Conventional methods for desalination of water and wastewater are usually not economically viable for providing the water required for agricultural production due to high energy consumption and equipment costs. This study aimed to evaluate the efficiency of magnetic nanobiochar produced from sugarcane bagasse to remove sodium ions from agricultural wastewater under the influence of a magnetic field. Non-nanoactive, nanoactive, and magnetic nanoactive adsorbents were produced using a pyrolysis process in an electric furnace at 600 °C, chemical activation with potassium hydroxide, and magnetization with a combination of hexahydrate ferric chloride and heptahydrate ferric sulfate. The results showed that the highest removal rates of chloride ions (44.6%) and sodium ions (58.3%) were obtained in the magnetically activated nano-biochar under the influence of a magnetic field of 0.5 Tesla, for an activator-to-biochar ratio of 3, a microwave power of 400 W, and an activation time of 10 minutes. Surface analyses including FT-IR spectroscopy and scanning electron microscopy (SEM) confirmed that the hydroxyl, carboxyl, and carbonyl functional groups on the surface of the adsorbent play a key role in the adsorption of sodium and chloride ions. It was also observed that the application of a magnetic field improved the orientation of the ions towards the adsorbent and weakened the hydrogen bonds in water, which led to an increase in the efficiency of the adsorption process. This study shows that magnetic nano-biochar, under a magnetic field, could be an economical and sustainable solution for reducing the salinity of agricultural wastewater.
 


Page 2 from 2     

© 2026 CC BY-NC 4.0 | Journal of Water and Soil Science

Designed & Developed by: Yektaweb

تحت نظارت وف ایرانی