Showing 2 results for Mirzaee
M Mirzaee, S Ruy, Gh Ghazavi, C Bogner,
Volume 12, Issue 46 (1-2009)
Abstract
At present, soil surface characteristics (SSC) are recognised as key parameters controlling infiltration rates, runoff generation and erosion. Microtopography of surface among SSC is the main one. The work presented in this paper is based on a set of digital elevation models (DEMs) supplied by two different methods: Laser roughness-meter and photogrammetry method. We used two maquettes. The used maquettes correspond to varying roughness (rough and soft roughness). These methods were compared using different statistical parameters of SSC such as heights and slopes histograms. In addition, we studied estimation of Random Roughness (RR) coefficient and Maximum Depression Storage (MDS). RR is considered as an indicator of microtopography and it is one of the main parameters influencing erosion and runoff-infiltration processes. The obtained RR by photogrammetry method showed, on average, 10 percent difference from laser method for soft maquette and 5 percent for the rough maquette. The range of this difference for the MDS varies from 2 to 34 percent, i.e., maximum 0.17 millimetres. In this study, photogrammetric method gives the DEMs with a lower slope for the rough maquette (on average 40.5 versus 46 for the laser method) and higher slope for the soft maquette (about 23.5 versus 20.7 for the laser method). The results showed the DEMs provided by photogrammetric method is able to perform accurate estimation for RR and provides good estimation for the MDS. Therefore, it can be useful in erosion and hydraulic studies.
N Shahmirzaee, S Kamgar,
Volume 13, Issue 47 (4-2009)
Abstract
One of the most important goals of precision farming is preparing yield map. Recently in Iran, planting of corn has received special attention. Therefore, among the different methods of yield measurement such as using impact sensor at the outlet port of forage harvester (chopper), displacement sensors at feed rollers of forage harvester, continuous measurement of discharged material to trailing wagon and using the torque meter, the present study made use of the torque meter method. This method consisted of a torque transmitting shaft equipped with laser-based encoders to monitor twist in a real time mode. The unit output could be exported to a computer via a microcontroller installed into the interface device. For calibration of the torque meter output with material feed rate in lab conditions, a conveyor was used to feed homogenous amount of material at a specific rate to the chopper. The experiment was conducted at 3 feed rates of silage corn and at 3 feed roll speeds of the chopper with 3 replications. Correlation between the feed rate and recorded power at different gears of the chopper was established. Relationships between feed rate and recorded power of the chopper at gears 1, 2 and 3 were linear with calculated R2 of 0.95, 0,98 and 0.98, respectively.
