Search published articles


Showing 2 results for Degree of Milling

M. Heidari Soltanabadi, A. Hemmat,
Volume 11, Issue 1 (4-2007)
Abstract

Studies show that excessive rotation of rice, when the grains revolve inside the milling chamber, increase the breakage. Ease of grain movement in the milling chamber could minimize this problem by utilizing screw conveyor at the first part of rotor. In this study the rotor of a conventional milling was equipped with a screw conveyor. The effects of two rotor types (modified and conventional rotors), three output rates (412, 654 and 915 kg/h) and three blade distances from the agitator (11, 12 and 13mm) were examined on indices of rice quality using a split-split plot design. In this experiment, the percentage of whole white rice and breakage, degree of milling and milling performance index were either measured or calculated. Results showed that only the effect of blade distance on percentage of breakage was significant whereas the effect of feed rate on all measured parameters was significant. In addition, the interaction effects of rotor type and blade distance, rotor type and feed rate on percentage of whole white rice and breakage were significant, respectively. The milling performance index showed that the best conditions for both rotors can be obtained at output rate of 412kg/hr and 11or 12mm blade distance from the agitator. For this adjustment, the average of percentage of breakage in the modified and conventional rotors were 20.5 and 23, respectively.
M. Ghasemi Varnamkhasti, H. Mobli, A. Jafari, M. Heidari Soltanabadi, Sh. Rafiee,
Volume 12, Issue 44 (7-2008)
Abstract

Rice whitening is an important stage in rice milling process and improvement of the whitener machines has a remarkable effect on rice loss. To decrease the amounts of broken rice and losses, the rotor of the blade whitener was equipped with screw conveyor. To investigate the effects of rotor speed (in four levels: 600, 700, 800 and 900 rpm) and output rate (in three levels: 400, 500 and 600 kg/h) on quality of milled rice, a factorial design with randomized complete block experiments with three replications were conducted. In this study, Sorkheh variety (a medium rice variety), which is one of the prevailing varieties in Esfahan, was used. The results showed that the lowest breakage percentage (20.92%) occurred at rotor speed of 700 rpm with an output rate of 600 kg/h and the best degree of milling (6.33%) took place at rotor speed of 600 rpm with an output rate of 400 kg/h. The best rice quality (low broken rice and high degree of milling) was observed at rotor speed of 600 rpm with 500 kg/h output rate.

Page 1 from 1     

© 2024 CC BY-NC 4.0 | JWSS - Isfahan University of Technology

Designed & Developed by : Yektaweb