Reza Aminpour, Sayed-Farhad Mousavi,
Volume 1, Issue 1 (4-1997)
Abstract
In order to determine the effects of number of irrigations on stages of development, yield, and yield components of cumin, an experiment was conducted in 1993 - 94 growing season with a randomized complete block design and four replications. The location of the experiment was Isfahan University of Technology Research Station in Shervedan Field. The irrigation treatments were: I1- Irrigation after planting I2- Irrigation after planting and at the stage of full standing of plants I3- Irrigation after planting, full standing of plants, and anthesis and I4- Irrigation after planting, full standing of plants, anthesis, and beginning of grain filling stage. The stages of development (from emergence to anthesis) occurred simultaneously in all treatments. However, the water deficit in I1 and I2 caused the plants to reach their physiological maturity 5 days sooner than the other two treatments. The time intervals between anthesis and physiological maturity in I4 and I3 treatments were 12 days and 5 days longer than those in the other two treatments, respectively. The grain yield of I1 and I2 were approximately 60% of I3 and no significant difference was observed between the grain yields of I1 and I2 treatments, nor between I3 and I4 treatments. The grain yields in I3 and I4 treatments were about 1742 and 1800 Kg/ha, respectively. The number of umbels per plant, the most important grain yield component, was greater in I3 and I4 than the other two irrigation regimes, but the number of seeds per umbel and 1000-seed weight of I3 and I4 were lower than that in I1 and I2 treatments.
M Moradi, A Zomorodian,
Volume 13, Issue 48 (7-2009)
Abstract
In this work, a cabinet solar dryer for thin layer drying of Cuminum cyminum was evaluated in two conditions (Indirect and Mixed). Four levels of drying air flow rates (three active and one passive) were adopted. The experiments were performed in a completely randomized Block design pattern in three replications. Drying durations were kept constant (90 min) for all the experiments. Average initial moisture content of Cuminum cyminum was 43.5 %( db) and the product was set to be dried for 90min in the solar dryer (average 8%d.b). The effects of the drying air flow rates and modes of drying were highly significant in final moisture content of Cuminum cyminum. Duncan test was selected to evaluate the effects of different factors on average moisture content of the samples. The results showed that the passive air flow system in mixed mode drying conditions for drying the Cuminum cyminum was best. The drying duration for the mentioned condition was 55min to dry the product from 43.5% to 8 %( db). The experiments were conducted each sunny day of August-September 2007 from 11.30 till 13.The average solar irradiance was recorded 750 W/m2 average ambient air temperature was32°C and average ambient relative humidity was20%. Using the dryer in the best selected conditions reduced the moisture content of the product from 43.5% to 4.95% after 90 min.
