Showing 6 results for Industrial
M. Ahmadpour Borazjani, G.r. Soltani,
Volume 4, Issue 2 (7-2000)
Abstract
Marine products are currently important in Iran due to the following reasons: 1) aquatics are recognized as safe and healthy food by food scientists 2) because of low dependence of fishing technology on foreign resources, they are more reliable sources for protein and food security. Therefore, it is important to increase labor productivity using advanced fishing technology under a sustainable fishery management policy. In general, the prevailing methods of fishing in the southern coasts of Iran can be classified into three groups based on the level of technology and the length of journey made: traditional, semi-industrial, and industrial. In this study, labor productivity in the traditional and semi-industrial groups were compared using data obtained from a sample of 35 fishermen in Bushehr Province. To determine the marginal and average labor productivities, transcendental production functions were estimated for fish and shrimp, separately. The findings indicated that the marginal and average productivities of labor in semi-industrial fishing were significantly higher than in traditional fishing.
M. A. Nazari, H. Shariatmadari, M. Afyuni, M. Mobli, Sh. Rahili,
Volume 10, Issue 3 (10-2006)
Abstract
Sewage sludge and effluents, as cheap sources of irrigation water and fertilizer, can supply plants with water and nutrients however, contamination of these sources with heavy metals and the possibility of human food chain contamination using these sources should be considered. In this research, the effects of industrial sewage sludge and effluents on concentration of some nurtients, heavy metals and sodium and dry matter yield of wheat (Triticum aestivum), barley (Hordeum vulgare) and corn (Zea mays) were investigated. The experiment was carried out in a greenhouse using a complete randomized design with four replication. The treatments comprised well water, well water + sewage sludge(50 tons/ha), and three industrial effluents from Iran Polyacryl factory including the cooling tower, the over flow and the factory outlet effluents. Chemical analysis showed the following results: The concentration of the elements in the sludge and the effluents were below the critical contaminating levels. The application of the treatments did not supply enough nitrogen for corn the cooling tower effluent could not supply enough nitrogen for wheat and barley all the treatments supplied enough P for wheat. None of the treatments could supply enough P for corn. The cooling tower, over flow and the factory outlet effluents could not supply enough P for barley, the micronutrient and heavy metal concentrations in the plant tissues using the effluents and the sewage sludge were higher than those for well water the dry matter yield of plants’roots and shoots was highest using well water + sludge and in comparison with the well water, effluents could increase the shoot dry matter yield.
A.h Khoshgoftarmanesh , A Sanaei Ostovar ,
Volume 13, Issue 50 (1-2010)
Abstract
The objective of this study was to evaluate the possibility of using treated industrial by-products as a zinc (Zn) source and compare their Zn availability and efficiency to ZnSO4. A greenhouse factorial experiment in a completely randomized block design was conducted with corn (Zea mays L.) in triplicates. Treatments included three Zn sources (ZnSO4, IUT-UT in size of < 1 mm and IUT-UT in size of 2-3 mm) at three rates (0, 20 and 40 kg ha-1). The results showed that Zn application both in the form of ZnSO4 and treated industrial by-products significantly (P < 0.05) increased the growth and shoot dry matter yield of corn. Shoot dry matter weight of corn in pots that had received IUTUT was higher compared to those that had received ZnSO4. The highest shoot dry matter weight was produced at the IUT-UT treatment in size of < 1 mm. Increased fertilizer rate significantly (P < 0.05) enhanced shoot and root Zn concentration. However, this increase was higher in ZnSO4 treatment as compared to the IUT-UT treatments. Application of the IUT-UT caused a significant increase in shoot Fe concentration of corn. Shoot and root Cd concentration in all experimental treatments was less than 0.02 mg kg-1. The results showed that IUT-UT can be used as a slow-release Zn fertilizer with low impurity.
Z. Mahmoodi, H. Khademi ,
Volume 18, Issue 67 (6-2014)
Abstract
Atmospheric dust is an important source of heavy metals, particularly in urban environments. Heavy metals can easily attach to dust particles and be distributed in large areas. The objective of this study was to evaluate the status of major heavy metals in the atmospheric dust of Isfahan and adjacent cities. A total of 144 dust samples were taken during a period from August to December 2010 from Isfahan, Khomeynishahr, Falavarjan, Mobarake and Zarinshahr cities. Dust samples were extracted with HNO3 65% and the total concentration of metals including Pb, Zn, Cd, Cu, Ni, Co, Cr and Mn in the samples was measured by an atomic absorption spectrometer. The mean concentration of these metals was 223.5, 470.3, 3.5, 71.0, 82.0, 26.5, 24.4 and 426.3 mg kg-1, respectively. Results indicated that heavy metals concentration in any area was different depending on the source of pollution and it was much higher than the mean concentration of the corresponding heavy metal in soils. Besides, the highest deposition rate of all the heavy metals in this study was found in November-December period. This could be attributed to an increase in the use of heating systems and also to a temperature inversion event prevailed in the area. Atmospheric deposition seems to be an important pathway of heavy metals addition to soils. For example, it is responsible for 35-91% and 12-47% of Pb and Cd entering the soil in the area, respectively.
A. Khosravi-Dehkordi, M. Afyuni, A. Soffianian,
Volume 20, Issue 77 (11-2016)
Abstract
Pollutants are considered the disturbing factors of environment, and among them the heavy metals are more important considering their non-degradability and physiological effects on organisms in low concentrations. The goal of this research was to investigate the effect of industrial landuse on Cd and Pb concentrations in surface soils of the southwest Isfahan. According to satellite images and topographic maps (1:50000) of the study area, soil samples (depth: 0–20 cm) were collected using random sampling. A total of 38 surface soil samples were obtained from industrial areas (lowest distance = 1480 m) in the area of 73481 ha. Total concentrations of Cd and Pb in the digested solution were measured by Atomic Absorption Spectrophotometry (AAS). Using Arc GIS, the spatial distribution patterns and Cd and Pb variography of samples were analysed and finally the best models of spatial distribution of heavy metals were achieved. The primary results showed that the mean concentrations of Cd, and Pb of surface soil samples in industrial areas were 1.8 to 31.5 mg Kg-1 higher than the world’s mean values, respectively. Although the mean concentrations of Cd and Pb were respectively 8 to 700 mg Kg-1 lower than the standard of Iranian Department of Environment for industrial landuse.
E. Chavoshi, M. Afyuni, M. A. Hajabbasi,
Volume 22, Issue 2 (9-2018)
Abstract
This study covers a large agricultural and industrial area of Isfahan province, including three types of land use, i.e., agricultural, uncultivated, industrial and urban types. A total of 275 samples from surface soil (0-20 cm) were collected and water soluble fluoride concentrations of them were measured. The spatial structure of water soluble fluoride in the soils was determined by omnidirectional variogram in the GS+ software. The spatial distribution of water soluble fluoride in the soil was mapped by employing the point kriging method in the SURFER software. The results showed that the mean of the water soluble fluoride concentration in Isfahan soils (0.85 mg L-1) was higher than the mean world soils (0.53 mg L-1). The water soluble fluoride showed moderate spatial dependence, indicating that the spatial variability of water soluble fluoride was mainly controlled by intrinsic and extrinsic factors. The mean water soluble fluoride concentration was significantly higher in agricultural and urban areas, as compared with the uncultivated land. This could be due to application of phosphate fertilizer in agricultural areas and the atmospheric fallout of fluoride from the industrial sources such as steel factories. According to the generated kriging map, the higher concentration of fluoride was mainly recorded around the Zayande Rood River and in the central and western parts of the study area.
