Showing 8 results for Logging
M. Naderi Khorasgani, A. Karimi,
Volume 11, Issue 42 (1-2008)
Abstract
This research was carried out to study the impacts of geomorphologic characteristics of claypan on land use and land degradation. Databank of the study area was constructed and digital terrain model of claypan was prepared. By using GIS techniques spatial distributions of the subsurface drainage network, sediment transportation index and wetness index were calculated. The results indicate that the depth to the claypan is between 0 (where the pan is exposed at the surface) to 605 cm. There are several depressions in the claypan which are filled by new sediments. Each depression has a catchment which is charged by the drainage water of its attributed lands. While a depression drains naturally or synthetically, the attributed soils over the depression are in non saline or moderate salinity condition otherwise, a marshland, a waterlogging area or a salt crust zone develops over there. The results also indicated that soil surface salinity is a function of depth to claypan and drainage condition of area. The trends of salinity extension are different for closed and open catchments and the depth to the claypan could be estimated using electrical conductivity. The results also show that analysis of microtopography of soil surface and soil stratification should be considered for designing irrigation and drainage networks.
M Lotfalian, B Majnonian, M Rezvanfar, A Parsakho,
Volume 12, Issue 46 (1-2009)
Abstract
In this research, the logging and wood extraction damages caused by wood and paper companies was investigated. The average volume per hectare of compartments 17 and 28 of Waston watershed and Compartment 7 of Alandan watershed was more than 150 cubic meters. So, these compartments were selected as the suitable research sites. The systematic randomized sampling method with 1000 m2 circular plots was used to assess the damages to residual stands and 100 m2 circular plots was used to assess the damages to regeneration. Sampling in skid trail was done with one hundred percent inventory method with a width of 12 meter. Results of this study indicated that 3.2 percent of regeneration was damaged in felling and bucking operations and 4.8 percent of regeneration was also damaged after winching and skidding operations. Most of these damages occurred for thicket stage. The felling and bucking operations damaged 13.6 percent of the residual stand. The amount of damage to the stand after skidding including the whole logging damages equals 15.5 percent. Unnecessary damages to stand and regeneration could have been avoided by selecting the best harvesting method, skidding practices, adequate incentives/disincentives and appropriate supervision.
F Tavnkar, B Mjnonian, A Eslam Bonyad,
Volume 13, Issue 48 (7-2009)
Abstract
Forest future depends on forest stands regeneration. Soil is one of the principal capitals in the forest area. It is important to minimize damages to the forest ecosystem during logging operation. In forestry and forest management, it is significant to know the effect of forest logging damages on regeneration, sapling and soil compaction. This study was carried out in Asalem Beech forest area, in the north of Iran. The forest was harvested by selective cutting method. A systematic and randomized sampling method was used for data collection. Analysis of variance (ANOVA) techniques and binomial distribution were used for data analysis. The results showed 14.5 ± 0.99 percent of regeneration and saplings of forest stands were destroyed and damaged by logging operations with 20 m3/ha intensity per year. 9.12 ± 0.83 percent of saplings were totally destroyed and 5.3 ± 0.63 percent were damaged. These damages were caused due to felling, accumulating, skidding and landing. Soil bulk density in range of 0-10 cm depth, logging and skid trails areas were increased 17.54 and 35.61 percent, respectively. To reduce logging damages and soil compaction in forestry, and manage the forest, we need a suitable organization of timber extraction operation, careful designing and standard construction of skid trails on the basis of logging maps before felling the trees down.
N. Najafi, S. Mardomi, Sh. Oustan,
Volume 15, Issue 58 (3-2012)
Abstract
The effects of waterlogging, sewage sludge and manure on the Fe, Mn, Zn, Cu, Pb and Cd uptake and concentrations in roots and shoots of sunflower (Helianthus annuus L.) were investigated in greenhouse conditions. A factorial experiment based on a completely randomized design with three replications including duration of waterlogging at five levels (0, 2, 4, 8, 22 days) and source and amount of organic fertilizer at five levels (0, 15 and 30 grams of both manure and sewage sludge per kg of soil) was conducted. The results showed that by increasing the duration of waterlogging, the Mn uptake and concentration in shoots and Mn concentration in roots increased but Mn uptake in roots did not change significantly. The uptake and concentration of Fe in shoots and Cd concentration in shoots and roots initially increased and then decreased after soil waterlogging, while Zn and Cu concentration of roots increased after an initial decrease. The effect of soil waterlogging on the Pb, Cu and Zn concentrations in shoots was not significant. By application of sewage sludge and manure the uptake and concentration of Fe, Mn, and Zn in shoots and Cu uptake in shoots increased but the uptake and concentration of Pb in shoots increased only by application of sewage sludge. The effect of source and amount of organic fertilizer on the Cd uptake and concentration in shoots, Cd concentration in roots and Cu concentration in shoots was not significant. By application of sewage sludge the root concentration of Fe, Mn, Cu and Zn increased but root concentration of Cd and Pb did not change significantly. The maximum uptake of heavy metals in shoots was obtained by application of 30 g sewage sludge/kg of soil. The effect of soil waterlogging on the heavy metals uptake and concentrations in the roots and shoots was dependent on the source and amount of organic fertilizer. Sunflower plant accumulated Fe, Mn, Zn, Cu, and Pb in roots while the Cd concentration in roots did not differ with shoots significantly.
N. Najafi, H. Towfighi,
Volume 18, Issue 67 (6-2014)
Abstract
Phosphorus behavior in waterlogged soils is significantly different from non-waterlogged soils. Changes in available phosphorus and inorganic phosphorus fractions after waterlogging in the paddy soils of north of Iran were studied in a laboratory research. A factorial experiment in a completely randomized design with two replications was performed with factors of soil at 14 levels (10 alkaline-calcareous and 4 non-calcareous or acid soils) and duration of waterlogging period at three levels (0, 30, 90 days). At the end of waterlogging period, phosphorus fractions in calcareous soils by Jiang and Gu method and in non-calcareous soils by Kuo method and available-P by Olsen method were determined. The results showed that the level of available-P in all soils was increased 90 days after waterlogging (on the average 2.3 times). In general, all P fractions were changed significantly after waterlogging and the amount of change was different depending on P fraction, soil type, and duration of waterlogging period. These results indicated the complex behavior of P in soils. The Al-phosphates were increased in 12 out of 14 calcareous and non-calcareous soils 90 days after waterlogging compared with air-dry soil. The Fe-phosphates were decreased in 9 out of 10 calcareous soils 90 days after waterlogging compared with air-dry soil while the effect of duration of waterlogging period on the Fe-phosphates in non-calcareous soils was not significant. The readily soluble-P in non-calcareous soils increased 30 and 90 days after waterlogging. The results indicated that some inorganic P fractions transformed into other fractions and probably organic P transformed into inorganic P during soil waterlogging period.
M. Sarmast, M. H. Farpoor, M. Sarcheshmehpoor, M. Karimian Eghbal,
Volume 18, Issue 68 (9-2014)
Abstract
Biocalcite infilling and bridging in a sandy soil was studied in the present research. Effects of 2 bacterial species (Sporosarcina pasteurii and Sporosarcina ureae), 3 reactant concentrations (0.5, 1.0, and 1.5 M of urea and CaCl2 mixture), and 6 reaction times (12, 24, 48, 96, 192, and 288 hr) on saturated hydraulic conductivity and mechanical strength of a sandy soil were studied as a factorial experiment. Soil samples were selected from sand dunes of Joopar area, Kerman Province. Bacterial inoculums and reactant solutions were daily added to soil columns. Results of the study showed that S. pasteuriihad had a higher effect on decreasing hydraulic conductivity of the treated samples (11.57 cm/h) compared to the blank (41.61 cm/h) than S. ureae. Increasing reaction times (from 12 to 288 hrs) and reactant concentrations (from 0.5 to 1.5 M) decreased hydraulic conductivity by 49 and 16 %, respectively. S. pasteurii increased strength of treated samples up to 2.6 Mpa pressure compared to S. ureae. Reactant concentrations and reaction times increased soil strength significantly (2.13 and 4.1 Mpa, respectively). Micromorphological observation showed calcite crystals bridging soil particles and filling pore spaces.
C. Abdi, P. Fathi,
Volume 21, Issue 3 (11-2017)
Abstract
Drip irrigation is one of the new irrigation methods for optimum use of water resources and increase of irrigation efficiency. The emitters' clogging is the most important problem in these systems. The physical clogging is the most important factor in reducing the discharge and emission uniformity of emitters. The emitter position on the laterals and emitter spacing are the factors that affect the physical clogging rate of emitters. The objective of the present study is evaluating the effect of emitter spacing of drip irrigation tape on the physical clogging rate of emitters. For this purpose, a physical model of drip irrigation tape was designed and made at the laboratory. In this research, seamless and seamed irrigation tapes with emitter spacing equal to 10, 20 and 30 centimeters were used. Statistical analysis showed that emitters spacing have significant effect on clogging rate of emitters in seamless and seamed drip irrigation tapes. The results also indicated that seamless irrigation tapes with 30-centimeter emitters spacing, with clogging rate of 22 percent, have the least clogging. A comparison of clogging rate and uniformity coefficient of irrigation tape showed the higher performance of seamless irrigation tape in clogging condition.
H. Dabbaghi, M. Khoshravesh, M. A. Gholami Sefidkouhi,
Volume 22, Issue 2 (9-2018)
Abstract
Emitter clogging for using agricultural wastewater increases the operating costs and reduces the motivation of farmers. The new method to reduce the emitters clogging is the use of a Merus ring that does not have the problems of chlorination and pickling methods, such as pollution and high cost. Due to the importance of agricultural wastewater use, this study investigated the emitters clogging and the effect of Merus ring on the emitter's efficiency in a trickle irrigation system. The treatments including irrigation water (well water and wastewater) and modified water (irrigation with Merus ring and irrigation without Merus ring), as the main factor and the emitters type treatment including Irritec (D1), Corona (D2), Axios (D3), Netafim (D4), Polirood (D5), and Paya (D6) as the sub treatments were performed in three replications. The results showed that the agricultural wastewater caused the emitters clogging in irrigation water and modified water treatments, but over time, the Merus ring had a positive effect on the evaluation parameters of the emitters. For agricultural wastewater, in the first and last irrigation periods, the average discharge of emitters with the Merus ring was 0.05 and 0.33 Liter per hours, respectively, more than the treatment without the Merus ring. The uniformity coefficient of emitters in the first and last irrigation periods, in well water with the Merus ring, was 0.31%and 6.67%, respectively, more than that in the well water without the Merus ring. Also, the uniformity coefficient of emitters in the first and last irrigation periods in agricultural wastewater with the Merus ring was 0.85% and 12.10%, respectively, more than that in agricultural wastewater without the Merus ring. At the end of irrigation period, the results showed that Netafim and Axios had the best and weakest efficiency, respectively. In general, the emitters used in the treatment of well water with the Merus ring had the highest discharge and the emitters used in the treatment of wastewater without the Merus ring had the lowest discharge.
