Showing 6 results for Losses
A.a. Seraj,
Volume 5, Issue 2 (7-2001)
Abstract
Field studies of S. cretica Led. damage and potential crop losses on two important cultivars of sugarcane, NCo 310 and CP 57-614, were carried out in southern Khuzestan in 1998-1999.
CP 57-614 showed greater mean percentage of bored nodes and internodes (20.7%) than NCo 310 (11-2%). Apart from the direct losses in cane weight (cane yield) due to boring from the larvae, cane juice quality is also adversely affected, resulting in lower recovery of sucrose in the factory. Sugar per ton of stalks also was greater in NCo 310 (132 kg) than in CP 57-614 (110 kg). Estimated sugar losses were 0.11 tons ha-1 for every 1% bored and rotten stalks. Other indirect losses are also discussed.
E. Askari Asli Ardeh, S. Sabori, M. R. Alizadeh,
Volume 12, Issue 44 (7-2008)
Abstract
A considerable portion of threshing losses and waste of rice takes place in threshing stage. One of the effective factors in threshing losses and waste of threshing units, threshers and harvesting machines, is the drum speed. In this research, effects of three factors including drum speed (five levels), crop moisture content (two levels) and rice common varieties (four varieties) on threshing losses and waste were studied. The thresher T25 was used for the investigation. It has wire loop type tooth. Dependent factors included unthreshed grains percentage (threshing losses) and damaged grains percentage. The obtained data was analyzed by split–split plot test based on Complete Randomized Blocks Design. The mean values were compared using Duncan’s Multiple Range Test. The tests results revealed that significant effect of variety type and drum linear speed on threshing losses (P<0.01). Furthermore, the effects of variety type, moisture content and drum speed on damaged grains were also significant. The optimum drum speed was 14 m/s. The most and the least of threshing losses belong to Hashemy and Binam varieties, respectively. Among the tested varieties, Binam variety showed the highest percentage of the damaged grains. In general, decreasing the crop moisture resulted in increasing the mean damaged grain.
M. Ghasemi Varnamkhasti, H. Mobli, A. Jafari, M. Heidari Soltanabadi, Sh. Rafiee,
Volume 12, Issue 44 (7-2008)
Abstract
Rice whitening is an important stage in rice milling process and improvement of the whitener machines has a remarkable effect on rice loss. To decrease the amounts of broken rice and losses, the rotor of the blade whitener was equipped with screw conveyor. To investigate the effects of rotor speed (in four levels: 600, 700, 800 and 900 rpm) and output rate (in three levels: 400, 500 and 600 kg/h) on quality of milled rice, a factorial design with randomized complete block experiments with three replications were conducted. In this study, Sorkheh variety (a medium rice variety), which is one of the prevailing varieties in Esfahan, was used. The results showed that the lowest breakage percentage (20.92%) occurred at rotor speed of 700 rpm with an output rate of 600 kg/h and the best degree of milling (6.33%) took place at rotor speed of 600 rpm with an output rate of 400 kg/h. The best rice quality (low broken rice and high degree of milling) was observed at rotor speed of 600 rpm with 500 kg/h output rate.
M. Raeisi Asadabadi, M. R. Nour, R. Fattahi,
Volume 22, Issue 2 (9-2018)
Abstract
In order to optimize the irrigation system performance, it is essential to get information about water balance components in the farm. So, the objective of this study was evaluating the performance of the WFD device in determining water penetrated fate in the soil at each irrigation occurrence as one of the important components in evaluating the irrigation water efficiency. By having the water amount infiltrated in the root zone and the deep percolation amount collected and determined by WFD device, contribution of surface losses related to every irrigation occurrence can be determined by the employing water balance equation. This research was carried out in the form of completely randomized design blocks in three replications and under the treatments of 60, 80, 100 and 120% of the irrigation requirement supply of a potato plant in the research farm of Shahr-e Kord University in 2014. To gather the growing season data, before the planting operation, various WFD devices were installed at different depths and locations along furrow. In addition to WFD data, input discharge (using counter), output discharge (measured by flume type 1) and values of soil moisture (theta-probe device) were collected during the harvesting season. The results showed that the mean Nash–Satcliffe coefficient of comparison between the values of calculated and measured surface losses corresponding to it, and also comparison of the values of the calculated and measured residual moisture before each irrigation occurrence were obtained to be 0.87 and 0.98, respectively. Quantity of this indicator in the two conducted comparisons represented the correct and exact performance of the WFD device in the farm operation evaluation. During the farm evaluation process under the experimental furrow, distribution uniformity averages in the experimental treatments were acquired to be 75.56, 83.78, 88.06, and 90.34%, respectively. Likewise, water amount average percolation of root zone (depth losses) in experimental treatments at each irrigation occurrence was measured to be 0.02, 0.07, 0.27 and 0.47m3 for each furrow.
S. Barkhordari, M. Hashemy Shahdany, A. Bagherzadeh Khalkhali,
Volume 23, Issue 3 (12-2019)
Abstract
Seepage losses and poor operational activities are the two main source of water losses throughout the agricultural water conveyance and distribution systems in irrigation districts. This study aims to investigate the performances of two strategies of “canal lining” and employing the “Canal Automation” in order to reduce the losses mentioned above. The investigation was carried out on a couple of main canal reaches of Moghan Irrigation Districts. Two numerical models were simulated by Seep/w software to compare the seepage rate between the canal with and without concrete lining. The results reveal that the ability of concrete lining to reduce seepage losses along the canal is about 10%. Performance assessment of the “Canal Automation” strategy to minimize operational losses within the main canal was carried out employing Model Predictive Control (MPC). The results of the latter strategy indicate that employing the MPC not only reduces the operational losses along the canal by 15% but also improves the operation of the main canal so that the minimum efficiency and adequacy performance indicator was obtained 100% and 83% respectively. Therefore; due to Executive considerations and financial constraints in the same cases, the potential of each of the two strategies can be considered to reduce the conveyance and distribution losses and ultimately choose the most suitable option.
M.m. Matinzadeh, J. Abedi Koupai, M. Shayannejad, A. Sadeghi-Lari , H. Nozari,
Volume 25, Issue 4 (3-2022)
Abstract
Using water and fertilizer management at the farm level can be increased water use efficiency and reduce the volume of drainage water, fertilizer losses, and other pollutants in farmland with deep underground drains such as Khuzestan agro-industrial Companies. In the present study, a comprehensive simulation model for the water cycle and the nitrogen dynamics modeling was used for water and fertilizer management modeling on farmland of sugarcane in Imam Agro-Industrial Company using a system dynamics approach. To reduce irrigation water consumption and nitrogen fertilizer losses, five different scenarios were considered including four scenarios of water management consist of 5, 10, 15, and 20 percent reduction in the amount of irrigation water (I1, I2, I3, and I4) compared to the current situation of irrigation in Imam agro-industrial Company (I0), and one scenario of integrated water and fertilizer management (20% reduction in the amount of irrigation water and urea fertilizer 210 Kg/ha, I4F). The results of modeling showed that the scenario of I4F caused to reduce 31, 70, 71, 70, and 85 percent of the cumulative volume of drainage water, cumulative nitrate and ammonium losses, total losses of cumulative nitrate, and ammonium by tile-drain and cumulative losses of denitrification process, respectively. Thus, the implementation of this scenario, not only saves water and fertilizer consumption but also reduces environmental pollution effectively. So the scenario of I4F (amount of irrigation water for six months 2656 mm and urea fertilizer 210 Kg/ha) is recommended for sugarcane in the Imam agro-industrial Company.
