Showing 6 results for Tape Irrigation
A. Karimi, M. Mazardalan, M. Homaeia, A. M. Liaghat, F. Raissi,
Volume 11, Issue 40 (7-2007)
Abstract
In Iran, fertilizers are mainly applied directly to soil. In such conditions, the yield and fertilizer use efficiency are usually low. The simultaneous application of fertilizers and irrigation water (fertigation) is an appropriate alternative to increase the efficiency of applied water and fertilizers. The objective of this study was to investigate the effect of various irrigation and fertilizer amounts on efficiency of applied fertilizers when used as fertigation in a Tape irrigation system. A field experiment was carried out with sunflower as a completely randomized design with 20 treatments and 3 replicates. The fertilizers were applied by fertigation. Four levels of the water (60, 80, 100 and 120% treatments I1 to I4) and five rates of the recommended fertilizers (0, 60, 80, 100, and 120% treatments F0 to F4) were applied.The recommended amounts consisted of 400 kg CO(NH2)2, 50 kg KCl, 30 kg FeSO4, 30 kg MnSO4, 50 kg ZnSO4, 30 kg CuSO4, and 30 kg H3BO3 per ha. Tape irrigation was used for every treatment. The results indicated that in fertigation method, there were significant differences ( P≥0.01) in fertilizer use efficiency (FUE) for the total dry matter and grain yield between treatments. The results showed that by increasing applied water, fertilizer use efficiency was increased and affected by fertilizers treatments. Thus due to higher availability of nutrients, fertilizer use efficiency increased. was Fertilizer use efficiency also decreased by increasing fertilizer rate. The results also demonstrated there were significant differences in all the treatments. The results showed that fertilizer use efficiency of K is higher than N and N is higher than P.
S. Akhavan, S. F. Mousavi, B. Mostafazadeh-Fard, A. Ghadami Firoz Abadi,
Volume 11, Issue 41 (10-2007)
Abstract
To investigate yield and water use efficiency (WUE) of potato with tape and furrow irrigations, an experiment was performed at Hamadan Agricultural and Natural Resources Research Center (Ekbatan station) in 2004. The experiment was arranged in a split-plot experimental design based on completely randomized block with 3 replications of irrigation water amount as the main factor (75%, 100%, 125% of cumulative evaporation from class A pan) and sub-factor of irrigation method [including tapes in the middle of furrow ridge on soil surface (TD0), tapes in the middle of furrow ridge at the depth of 5 cm (TD5), tapes on the sides of furrow ridge on soil surface (TS0), and furrow irrigation (F)]. The results indicated that yield of potato increased with increasing water use. Regardless of irrigation method, maximum (32.51 ton/ha) and minimum (19.33 ton/ha) yield of potatoes was achieved with 125% and 75% irrigation water treatments, respectively. The lowest yield (21.35 ton/ha) was obtained in furrow irrigation and the highest yield (28.91 ton/ha) belonged to tape irrigation (TD5 treatment). The highest WUE (4.68 kg/m3) belonged to tape irrigation (TD5 treatment) and the lowest WUE (3.32 kg/m3) belonged to furrow irrigation (F). The difference in WUE between 75% and 100% irrigation water treatments was not significant. The highest WUE (4.49 kg/m3) was achieved in treatment 125%. Also, it is more economical to use irrigation water treatment of 125%, as compared with other irrigation water treatments.
S. Samadvand, M. Tajbakhsh, K. Anvari, J. Ahmadaali,
Volume 18, Issue 70 (3-2015)
Abstract
An experiment was performed at the Miyandoab Agricultural Research Station to study yield and water use efficiency of furrow and tape irrigation systems in one-row and two-row planting patterns, and to investigate density of grain corn SC704. The experimental design was a completely randomized block arranged in Strip Split Plots with three replications in 2010. Irrigation treatments were applied in vertical plots, and planting arrays of different densities were applied in horizontal plots in the form of split plots. The vertical plots were comprised of four irrigation treatments, including three levels (80%, 100% and 120%) of water requirement by use of drip tape irrigation and 100% of water requirement in furrow irrigation, and the horizontal factor was a planting array in the form of single-row and two-row planting patterns and the sub factor was comprised of three levels: 75, 90 and 105 thousand plants per hectare. The results showed that furrow irrigation had the highest rate of grain yield, about 18.6 ton per hectare, and the treatments of tape irrigation of 120%, 100% and 80% had 18.4, 18.2 and 14.9 tons per hectare, respectively. Although the furrow irrigation treatment had higher yield than the rest, there was no significant difference between treatments except for the 80% of tape irrigation. Thus, by utilizing tape irrigation without a great decrease in the yield, water use efficiency improved. The comparison between treatments of tape irrigation of 80%, 100%, 120% and furrow irrigation led to grain yields of 2.3, 2.2, 1.9 and 1.4 kg/m3, respectively. Also, the highest water use efficiency and maximum yield were obtained from 90000 plants per hectare.
Z. Amiri, M. Gheysari, M. R. Mosaddeghi, M. S. Tabatabaei, M. Moradiannezhad,
Volume 23, Issue 2 (9-2019)
Abstract
Location of soil moisture sampling in irrigation management is of special importance due to the spatial variability of soil hydraulic characteristics and the development of root system. The objective of this study was determination of the suitable location for soil moisture sampling in drip-tape irrigation management, which is representative of the average moisture in the soil profile (θavg) as well. For this purpose, soil moisture distribution (θij) at the tassel stage of maize and one irrigation interval (68-73 day after plant) were measured at the end of season. The results showed more than 70% length of the root of plant was located in 30 cm of the soil depth. By accepting ±10% error in relation to the averaged soil moisture, some region of soil profile was determined which was in the acceptable error range and also near the averaged soil moisture (0.9θavg<θRec<1.1θavg). By overlapping θRec in one irrigation interval, the appropriate location for soil moisture sampling was the horizontal distance from drip-tape line to 20 cm and the depth of 10-20 cm from the soil surface. To determine the appropriate place for soil moisture sampling, the development of root system and the maximum concentrated root length density in the soil profile extracting the maximal soil moisture should be taken in to account, parallel with the averaged soil moisture.
O. Asadi Asadabad, S. H. Matinkhah, Z. Jafari, H. Karim Mojeni,
Volume 25, Issue 1 (5-2021)
Abstract
In order to investigate the effect of the type drip of irrigation methods, subsurface irrigation and furrow irrigation on the domestication of Hedysarum criniferum Boiss., an experiment with a randomized complete block design with three replications was implemented at Isfahan University of Technology for two years (2016 to 2018) . For this purpose, clay pipes were made and the plant was cultivated on the sides of clay pipes and types. Also, furrow irrigation treatment was applied as the control. During the experiment, all treatments received the same water and finally, some growth parameters were measured. The results of the study showed improvement in height (0.43 and 0.34), canopy cover (0.66 and 0.52), stem number (0.44 and 0.85), chlorophyll index (0.45 and 0.45), seed emergence (0.75 and 0.30), plant survival (0.78 and 0.55), yield (0.23 and 0.35), and water use efficiency (0.25 and 0.25) under type drip irrigation treatment, as compared to subsurface and furrow irrigation, respectively (P<0.05). In general, the type drip treatment is recommended in the early years of planting; however, since the maximum production potential of this plant is in the third year onwards, it is necessary to examine the results in the following years to recommend the proper irrigation method, especially the use of subsurface irrigation.
M. Farzamnia, M. Miran Zadeh,
Volume 26, Issue 4 (3-2023)
Abstract
The present study was carried out in the Mahyar region of Esfahan Province to determine optimum drip tape spacing for the wheat crops on a silty clay loam soil respecting grain yield as well as yield components, water use efficiency, and variations in the salinity within the soil profile. The experiment was performed for three years from 2017 to 2019 with a randomized complete block design with three replicates and four treatments. The treatments consisted of three tape spacings (A) at 45, (B) at 60, (C) at 75 cm, and the Control (D) was irrigated with the basin method. The same volume of irrigated water was applied to the drip treatments, A, B, and C in every irrigation interval, whereas for treatment D, the local farmers’ practice was followed. Based on the results from compound variance analysis, the treatment effect on both grain yield and biological yield, and on water use efficiency and harvest index was significant at 1% and 5% level of confidence, respectively. The mean water use efficiency in treatments A, B, C, and D was measured as 0.79, 0.79, 0.73, and 0.78 kg m-3; thus, treatments A, B, and D outperformed treatment C. A comparison between the salinity of the soil profile at the beginning and the end of the growing season revealed that the basin irrigation method was more effective on salt leaching than the drip tape system. The results of this study indicated that concerning water use efficiency and crop yield, drip tapes spaced at 45 or 60 cm outperformed those which were 75 cm apart. On the other hand, the work required for irrigation system installation as well as the amount of drip tape residues left on the field at the end of the growing season is larger for tapes spaced at 45 cm compared to those which are 60 cm apart. This will have a significant impact on farmers’ budgets and environmental issues. Therefore, it is recommended to lay the tapes 60 cm apart for the irrigation of wheat crops on silty clay loam soils.
