Search published articles


Showing 2 results for Water Drop Penetration Time
Effect of Petroleum Pollution on Soil Water Repellency and Structural Stability in Bakhtiardasht Plain, Isfahan
M. Kermanpour, M. R. Mosaddeghi, M. Afyuni , M. A. Hajabassi,
Volume 19, Issue 73 (11-2015)
Abstract

Petroleum pollution is an important environmental issue in most of the countries especially those have an oil industry. This study was conducted to investigate the effect of petroleum pollution on soil water repellency and its relation to soil structural stability in Bakhtiardasht area, Isfahan. Polluted and adjacent non-polluted locations were selected to be representative in the green space around the Isfahan Oil Refinery. Soil water repellency was assessed using water drop penetration time (WDPT) in the polluted locations. Soil sample with least aggregates disturbance were collected and selected soil physical and chemical properties were measured. Soil structural stability was evaluated using the wet-sieving method and mechanically dispersible clay (MDC) structural stability indices of mean weight diameter (MWD) and geometric weight diameter (GMD) of aggregates and MDC were then calculated. Results showed that the positive effect of petroleum pollution on the MWD and GMD become significant. Negative impact of petroleum pollution on MDC was also significant. Increment of total petroleum hydrocarbons (TPHs) increased the soil water repellency. A positive correlation was observed between soil water repellency and GMD. However, TPHs concentrations greater than 6.4% decreased the MWD and GMD presumably due to anionic repulsion between clay particles and hydrocarbon functional groups. Although greater water repellency increased soil structural stability in the polluted locations when compared to control locations, however, diminished water retention of polluted soil has created an unfavorable condition for the green space in the area.


Assessment of Physical and Hydraulic Properties of Three Rockwool Types in Comparison with Wheat Straw and Sawdust as Greenhouse Growth Media
Sh. Shahmansouri, M.r. Mosaddeghi, H. Shariatmadari,
Volume 27, Issue 1 (5-2023)
Abstract
According to the rapid population growth, the challenging issue of production of economic and suitable food sources has led to greater attention to soilless culture greenhouse production systems. Components of growth media in horticulture are usually selected based on physical and chemical properties and their abilities in providing enough water and oxygen for roots. This study was conducted to investigate the feasibility of using some agricultural wastes (i.e., sawdust and wheat straw) and three rockwool types (i.e., raw, ground, ground, and sieved) as substitutes for commercial greenhouse growing media such as cocopeat and perlite. Several hydraulic, aeration, and chemical properties including easily available water (EAW), air after irrigation (AIR), water holding capacity (WHC), water buffering capacity (WBC), saturated water content (θs), bulk density (BD), total porosity (TP), water drop penetration time (WDPT), pH, and electrical conductivity (EC) were measured and scored in the growth media. Raw rockwool had larger particles compared to ground rockwool, which resulted in its faster water release. Processing of the rockwool decreased the saturated water content and saturated hydraulic conductivity due to the decrease in particle size. Four growth media were scored as very good and one was scored as good. The highest and lowest scores belonged to sawdust (34) and ground rockwool (30), respectively. The studied growth media with high TP, EAW, and WHC and low BD, EC, and WDPT can be used individually or combined with other commercial substrates for greenhouse growth media.

Page 1 from 1     

© 2024 CC BY-NC 4.0 | JWSS - Isfahan University of Technology

Designed & Developed by : Yektaweb