Showing 3 results for Wet Sieving
A. Khazaei, M.r. Mosaddeghi, A.a. Mahboubi,
Volume 12, Issue 44 (7-2008)
Abstract
Soil physical and chemical properties, and test conditions might affect soil structural stability. In this study, the effects of test conditions as well as intrinsic soil properties on structural stability were investigated for selected soils from Hamedan Province. Mean weight diameter (MWD) and tensile strength (Y) of aggregates were determined by wet sieving method and indirect Brazilian test, respectively. The soil samples were pre-wetted slowly to matric suction of 200 kPa before the wet sieving. The pre-wetted samples were wet-sieved for 5, 10 and 15 min in order to simulate different hydro-mechanical stresses imposed on soil structure. Tensile strength of soil aggregates were also measured at air-dry and 500 kPa matric suction conditions. Short duration shaking (i.e. 5 min) could effectively discriminate the Hamedan soils in terms of structural stability due to their fairly low aggregate stabilities. The soil organic matter content had the highest impact on MWD followed by both clay and CaCO3 content. The same was true for the Y values i.e. OM played the highest role in mechanical strength of soil aggregates. The highest coefficient of determination (R2) was obtained between Y and the intrinsic soil properties for matric suction of 500 kPa. The organic matter content had an important role in water and mechanically stable soil aggregates. The results indicated that short-duration wet sieving (i.e. 5 min) and measurements of tensile strength at matric suction of 500 kPa could be recommended for aggregate stability assessment in Hamedan soils
E. Habibi, M. A. Asoodar, B. Khalil Mogaddam,
Volume 18, Issue 67 (6-2014)
Abstract
Extensive tillage leads to the degradation of soil structure and aggregate stability. The effects of three different tillage implements including (combination tillage, chisel packer and disk), three levels of soil water content including (0.5, 0.7 and 0.9 plastic limit), three working speeds including (6, 8 and 10 km/hr) and two soil textures including (loam and silty clay loam soils) were studied. The study was carried out in Khuzestan Ramin Agriculture and Natural Resources University, in 2011. Soil aggregate mean weight diameter (MWD), geometric mean diameter (GMD) as determined by wet sieving method and soil surface roughness (SSR) were measured. Results showed that chisel packer with 0.744 mm MWD produced largest soil aggregates in both soils because of using narrow blade and shanks and small rake angles compared to other tillage treatments. Soil aggregate size was shown larger than other tillage treatments where chisel packer was employed but it was not suitable because of deep furrow shapes. Combination tillage was able to make a better soil condition to be used for seeding where the experiment was conducted.
M. Kermanpour, M. R. Mosaddeghi, M. Afyuni , M. A. Hajabassi,
Volume 19, Issue 73 (11-2015)
Abstract
Petroleum pollution is an important environmental issue in most of the countries especially those have an oil industry. This study was conducted to investigate the effect of petroleum pollution on soil water repellency and its relation to soil structural stability in Bakhtiardasht area, Isfahan. Polluted and adjacent non-polluted locations were selected to be representative in the green space around the Isfahan Oil Refinery. Soil water repellency was assessed using water drop penetration time (WDPT) in the polluted locations. Soil sample with least aggregates disturbance were collected and selected soil physical and chemical properties were measured. Soil structural stability was evaluated using the wet-sieving method and mechanically dispersible clay (MDC) structural stability indices of mean weight diameter (MWD) and geometric weight diameter (GMD) of aggregates and MDC were then calculated. Results showed that the positive effect of petroleum pollution on the MWD and GMD become significant. Negative impact of petroleum pollution on MDC was also significant. Increment of total petroleum hydrocarbons (TPHs) increased the soil water repellency. A positive correlation was observed between soil water repellency and GMD. However, TPHs concentrations greater than 6.4% decreased the MWD and GMD presumably due to anionic repulsion between clay particles and hydrocarbon functional groups. Although greater water repellency increased soil structural stability in the polluted locations when compared to control locations, however, diminished water retention of polluted soil has created an unfavorable condition for the green space in the area.
