H Shahbazi, A Sadeghi, H Fazaeli, Gh Reis Ali, M Chamani,
Volume 13, Issue 47 (4-2009)
Abstract
In this research, samples of sugarcane bagasse were irradiated with various amounts (0, 100, 200 and 300 Kilogray) in an electron accelerator (TT200) to evaluate the effects of electron-beam irradiation on dry matter, neutral-detergent fiber (NDF) and acid-detergent fiber (ADF) degradability parameters. The first samples were dried and then ground for chemical analysis. The ruminal degradation parameters of the samples were measured in fistulated cow 3 (400 kg) at times of 0, 6, 12, 24, 48, 72 and 96 h by the terylene bag method. Data were fitted to non-linear degradation model of Orskov and McDonald to calculate degradation parameters of DM, NDF and ADF. The statistical analysis of degradation of various parameters and effective degradability was accomplished by using the GLM procedure of SAS. After variance analysis, the means were compared with Duncan,s new multiplerange test by using a completely randomized design. The washout fractions of DM as well as NDF and ADF increased linearly (P<0.05) with increasing electron irradiation dose, whereas the potentially degradable fractions of NDF and ADF decreased at first, and then, increased. Also, the degradation rate of the b fraction of dry matter increased. Effective degradability of DM, NDF and ADF increased linearly (P<0.05) with increasing irradiation dose. Electron irradiation at doses of 100, 200 and 300 kGy increased the effective degradability of DM, NDF and ADF at rumen outflow rate of 0.05/h (r) by about 7, 11 and 16% 2, 5 and 7% 3, 7 and 10%, respectively.
H. Shabani, M. A. Delavar, S. T. Fardood,
Volume 24, Issue 1 (5-2020)
Abstract
Today, to reduce the risks of contaminants, new remediation techniques have been focused on low-cost and environmentally friendly manners. Given the frequency of access, inexpensiveness and good physical and chemical properties, biochar has a high potential for the remediation of water pollutants. In this paper, the efficiency of chitosan engineered biochar (Bc-Ch) and pristine biochar (Bg-Bc) prepared from sugarcane bagasse biomass (Bg) in the Cd2+ removal in aqueous solution was investigated. To this aim, the effects of contact time, adsorbent dosage and solution pH on cadmium removal were evaluated by adsorption isotherms and Kinetic models. The results indicated that the Langmuir isotherm and the pseudo-second-order kinetic model could be well fitted with the process of cadmium biosorption. The maximum adsorption capacities of Bc-Ch, Bg-Bc and Bg ,according to Langmuir model, were found to be 32/78 mg/g, 11/57 mg/g and 2/23 mg/g, respectively. For these absorbents, the pseudo-second-order kinetic model showed the best fit to the experimental adsorption data. This study, therefore, indicated that the chitosan engineered biochar could be used as an effective, low-cost, and environmentally-friendly sorbent to remediate heavy metals contamination in the environment.
Z. Noori, M. A. Delavar, Y. Safari,
Volume 24, Issue 4 (2-2021)
Abstract
The present study was intended to improve the chemical properties of a saline-sodic soil using the individual application of alfalfa residue and two biochars produced from sugarcane bagasse and walnut shell, at the weighting ratio of 5%; their concomitant application with gypsum, aluminum sulfate and the mixture of these two chemical amendments was considered. The experiment was conducted in three replications using the factorial experiment in a completely randomized design. After four months of incubation, the soil samples were measured for their main chemical properties. The results showed that alfalfa residues were the most effective treatment to reduce the soil pH; so the concomitant application of this organic amendment with gypsum lowered the soil pH from 9.13 in the control (untreated soil) to 7.24. It was also observed that the addition of gypsum and/or aluminum sulfate to the soil led to the increase of the soil electrolyte concentration and consequently, the increase of soil electrical conductivity to three times greater than control, through an increase of ions, like calcium and sulfate in the soil solution. Increasing the soluble sodium concentration by replacing exchangeable sodium by other similar ions showed that the studied treatments enhanced the sodium adsorption ratio (SAR), which could be regulated by washing. Concomitant application of the walnut-shell biochar with gypsum had the most increasing effect on the soil SAR, enhancing it from 22.6 in the control to 54.3. Potassium was released from organic amendments, improving the soil general conditions; addition of chemical amendments elevated soil exchangeable potassium contents; however, the elevated soil available phosphorus contents were less influenced by chemical amendments application. As the conclusion, it seems that the positive impacts of the applied chemical and organic amendments would supplement each other; as a result, the concurrent use of both treatments not only improves the bad soil chemical properties, but also enhances the soil fertility.
Z. Nazari, M. Moeinaddini, S. Zare, R. Rafiee,
Volume 27, Issue 1 (5-2023)
Abstract
Due to the environmental problems caused by wind erosion, it is necessary to stabilize the dust centers with mulches. The objective of the present study was to determine and compare the optimum vinasse mulches based on mechanical indicators for sensitive soil stabilization to wind erosion. In this research, vinasse (0, 100, 200 g) is combined with bagasse (0, 25, 50 g), ash bagasse (0, 25, 50 g), filtercake (0, 12.5, 25 g), and one-liter water (81 treatments). At first, the treatments were determined in the appropriate range of salinity and acidity (35 treatments) and in the next step, the mechanical indicators have been measured after mulching on laboratory trays (2×30×100 cm). Optimum mulches have been determined based on five indicators by mean comparison (Duncan). The mean comparison showed that treatments 33, 30, 34, 32, and 19 show the mean difference between the groups based on layer thickness, impact resistance, compressive strength, and shear strength properly. It can be concluded that vinasse (100 and 200 g) with 50 g bagasse reduces the crack coefficient greatly, and the application of vinasse, bagasse, and filtercake does not affect the compressive strength and impact resistance.
