Volume 6, Issue 1 (Journal OF Welding Science and Technology 2020)                   JWSTI 2020, 6(1): 147-156 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Shayanfar P, Daneshmanesh H, Janghorban K. The effect of overlapping percent on microstructure and mechanical properties of laser cladding of Inconel 625 powder on ASTM A592 steel. JWSTI 2020; 6 (1) :147-156
URL: http://jwsti.iut.ac.ir/article-1-309-en.html
The effect of overlapping percent on microstructure and mechanical properties of laser cladding of Inconel 625 powder on ASTM A592 steel
P. Shayanfar * 1, H. Daneshmanesh1 , K. Janghorban1
1- Department of Materials Science and Engineering, School of Engineering, Shiraz University, Shiraz, Iran
Abstract:   (4857 Views)
In this study, the effect of overlapping percentage on microstructure and mechanical properties of a single-pass coating by Inconel 625 powder laser has been investigated for quench-tempered ASTM A592 steel. In order to have a structural analysis, the inter dendritic distance was evaluated. For this purpose, scanning electron microscopy (FESEM) and Digimizer software were adopted. In order to investigate mechanical properties, elastic modulus, toughness, and micro hardness were evaluated. For the evaluation of elastic modulus, Noop indentation method was used, and for toughness studies, Evans method was applied. After the investigation, it was found that in the overlapping of single-pass 50% coatings, the heat input value is lower than overlapping in single-pass 75% coatings. It also contains a finer structure with much higher mechanical properties. This is in such a way that the inter dendritic distance in single-pass 50% coatings is about 0.91 µm. The average diameter of the dendritic columns is about 0.32 µm, hardness value is about 10%, Knoop hardness is about 9 units, elastic modulus is about 37 GPa, and toughness is about 9 MPa m1/2 higher in comparison with the 75% overlapping case.
Keywords: Laser cladding, Inconel 625, A592 steel, Microstructure, Mechanical properties
Full-Text [PDF 4809 kb]   (1149 Downloads)    
Add your comments about this article : Your username or Email:
CAPTCHA
Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | Journal of Welding Science and Technology of Iran

Designed & Developed by : Yektaweb