Volume 9, Issue 1 (Journal OF Welding Science and Technology 2023)
JWSTI 2023, 9(1): 113-125 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Safari M, Ahadi A. Experimental investigation of the laser coating process of the inconel 718 powder on the H13 steel. JWSTI 2023; 9 (1) :113-125
URL: http://jwsti.iut.ac.ir/article-1-435-en.html
URL: http://jwsti.iut.ac.ir/article-1-435-en.html
1- Department of Mechanical Engineering, Arak University of Technology, Arak, Iran. , m.safari@arakut.ac.ir
2- Department of Mechanical Engineering, Arak University of Technology, Arak, Iran.
2- Department of Mechanical Engineering, Arak University of Technology, Arak, Iran.
Abstract: (2090 Views)
In the present research, the coating process of Inconel 718 powder on the H13 steel substrate by direct powder deposition method with the help of 1 KW continuous fiber laser has been investigated. Hence, the effects of process parameters such as laser power, powder feed rate and laser scanning speed on the geometrical characterstics of the clad such as height and width of the clad are examined. In order to perform a comprehensive investigation on the effect of input parameters and their interactions on the height and width of the clad, design of experiment method based on response surface methodology is employed. The results show that the laser scanning speed and powder feed rate are as the important factors affecting the clad height, so that the clad height increases with increasing powder feed rate and decreasing laser scanning rate. Also, it is proved that by increasing the laser power and decreasing the laser scanning speed the width of the clad is increased.
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
