Volume 6, Issue 2 (Journal OF Welding Science and Technology 2020)
JWSTI 2020, 6(2): 29-39 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Ghorbani Amir Y, Zolriasatein A, Torabian H. Effect of rotary friction welding variables on mechanical and physical properties of aluminum-copper tube joints. JWSTI 2020; 6 (2) :29-39
URL: http://jwsti.iut.ac.ir/article-1-326-en.html
URL: http://jwsti.iut.ac.ir/article-1-326-en.html
1- Yadegar-e-Imam Khomeini (RAH) Shahr-e-Rey. Branch, Islamic Azad University, Tehran, Iran
2- Non-Metallic Materials Research Group, Niroo Research Institute (NRI), Tehran, Iran
3- Tehran Central Branch, Islamic Azad University, Tehran, Iran.
2- Non-Metallic Materials Research Group, Niroo Research Institute (NRI), Tehran, Iran
3- Tehran Central Branch, Islamic Azad University, Tehran, Iran.
Abstract: (4158 Views)
The aim of this study is to investigate the effect of rotary frictional welding process variables on microstructure, mechanical and physical properties of copper-aluminum dual-tube pipes. For this purpose, using a thermosetting friction welding machine, a copper pipe (99.44% purity) with a similar diameter aluminum tube (1050), was welded in three different conditions with different friction pressures and forging, and then by metallographic, hardening and microstructural testing it placed. The results of this study showed that with increasing friction pressure from 10 and 15 Bar respectively, in the interconnected phase, fuzzy interclass metal samples were created and caused a great loss in the deformation percentage and tensile strength of the interconnected sample. Also, with the reduction of frictional pressure and the removal of forging pressures down to 5 Bar, there is no proper bond between the two samples and formed in the interface between porosity and cracking. The most suitable result for the microstructure, mechanical and physical properties of the samples is in tubes with an outside diameter of 15 mm and an inner diameter of 10 mm, for samples having a friction pressure of about 10 Bar and a forge pressure of 15 Bar. The presence of intermetallic Al-Cu phases such as CuAl2, due to higher electrical resistance and ceramic nature, increases the electrical resistance of the joint and, on the other hand, the presence of cracks and pores has reduced the flow rate and eventually increased electrical resistance of the samples
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
