Morteza Abbasi, Hamidreza Najafi, Alireza Khodabandeh,
Volume 4, Issue 1 (8-2018)
Abstract
Dissimilar welding of AISI 304L austenitic stainless steel to AISI 409 ferritic stainless steel with GMAW process usingtwo Ar-O2 and Ar-CO2 shielding gas mixtures was studied. ER316LSi and ER309LMo filler metals were chosen by considering 5 and 15% delta ferrite according to the Schaeffler equations and diagram. Based on the observations, both filler metals accompanied by Ar-2%O2 shielding gas resulted in acceptable weldments. Yield strength and UTS of tensile samples were 288 and 424 MPa, respectively. All tensile samples fractured in the ferritic base metal. Microhardness test results demonstrated that the maximum hardness of 190-200 HV was obtained from ER316LSi weld metal. The minimum hardness of 145 HV was found in the HAZ of 409 side mainly due to the grain coarsening. Microstructural examinations revealed needle-like precipitates formed perpendicular to each other in the HAZ of 409 stainless steel. It seemed that the pre-existing TiC precipitates evolved into the needle shape precipitates as a result of rapid heating and cooling rates during the welding process.
Ali Rahimi, Morteza Yazdizadeh, Masoud Vatan Ara, Majid Pouranvari,
Volume 9, Issue 2 (8-2025)
Abstract
Wire-arc additive manufacturing (WAAM) is a prominent technique for producing large metallic components due to its high deposition rate. Utilizing austenitic stainless steels in this process not only reduces production costs but also provides greater design freedom. Among these steels, SS310, known as heat-resistant steel in the industry, offers excellent oxidation resistance and high-temperature performance. However, it is highly susceptible to hot cracking during welding and additive manufacturing processes. In this study, the microstructure and mechanical properties of SS310 fabricated using WAAM with Cold Metal Transfer (CMT) and Gas Metal Arc Welding (GMAW) processes were compared. The results revealed that the CMT process, due to its lower heat input, effectively reduces the susceptibility of SS310 to hot cracking compared to the GMAW process. These findings emphasize the importance of selecting an appropriate process to achieve high-quality components and minimize structural defects.
