Volume 30, Issue 2 (Dec 2011)
2011, 30(2): 23-35 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
H. Omidvar, B. Fallah Ghanbary, M. Tamizifar. Flow behavior of commercial grade Ti-6Al-4V with lamellar structure in isotherm forging and kinetic analysis of process. Journal of Advanced Materials in Engineering (Esteghlal) 2011; 30 (2) :23-35
URL: http://jame.iut.ac.ir/article-1-526-en.html
URL: http://jame.iut.ac.ir/article-1-526-en.html
Amirkabir University of Technology, Department of Metallurgical Engineering , omidvar@aut.ac.ir
Abstract: (7141 Views)
In this paper, plastic flow behavior and micro structural evolution of Ti-6Al-4V alloy in temperature range of 750-1050 °C and strain rate range of 0.001-0.1 (S-1) in isotherm compression condition were investigated. The purpose was to estimate activation energy of globularization of lamellar structure and analyze this process kinetically. True Stress-strain curves obtained at the temperatures below 950 °C indicate a limited amount of flow softening imputed to a dynamic recrystallization occuring at about 950 ˚C. In contrast, at higher temperatures, the flow stress increases linearly with plastic strain until at temperatures about 1015°C where flow stress becomes nearly independent of the temperature. By analyzing flow stress data via Zener-Hol-lomon and sellars equation, Q activation energy of dynamic recrystallization was estimated and structural equation of plastic flow was obtained, whixh were comparable to results raeched by other investigators.
Type of Study: Research |
Subject:
General
Received: 2015/02/9 | Accepted: 2015/05/5 | Published: 2015/05/5
Received: 2015/02/9 | Accepted: 2015/05/5 | Published: 2015/05/5
Send email to the article author
